Quick Strap Lite: DIY Removable Velcro Flash Strap

Start with 3/4" hook and loop tape (Velcro brand used here)

DIYflashremovablestrapvelcro

Tennis racket grip tape provides lots of traction. This pack makes 9 straps with this recipe. I used yellow this time for contrast, but it's available in many different colors, including black for those who want to look more "pro".

DIYflashremovablestrapvelcro

Cut off the tapered part of the grip tape

DIYflashremovablescissorsstrapvelcro

Make sure that there is enough grip tape to wrap around the flash, overlapping the width. For the Canon 550EX, that's 12 inches. Most flashes will be shorter. Adjust the subsequent directions accordingly.

DIYflashremovablestrapvelcro

Cut twelve inch strips of grip tape

DIYflashremovablescissorsstrapvelcro

You should get 3x 12" inch strips from one roll of grip tape

DIYflashremovablestrapvelcro

Peel off the clear protective film from the grip tape. This shinier side will face your flash.

DIYflashremovablestrapvelcro

Lay the grip down straight, and with the shiny side down, matte side up

DIYflashremovablestrapvelcro

Cut 12" strips of hook tape. That's the harder half of velcro

DIYflashremovablescissorsstrapvelcro

Stick the loop (softer) velcro tape to the grip tape

DIYflashremovablestrapvelcro

Trim off any overhanging tape on either side.

DIYflashremovablescissorsstrapvelcro

Cut 2" of hook tape. Set aside for later

DIYflashremovablescissorsstrapvelcro

Attach the hook tape to the end of the strip, on the shiny side of the grip tape

DIYflashremovablestrapvelcro

Starting with the top of the flash, wind the strip around your flash.

DIYflashremovablestrapvelcro

The finished strip provides a more manageable amount of grip for your diffusers and gels.

DIYflashremovablestrapvelcro